AC57 Special Configuration
The AC57 is a special purpose configuration. Before ordering check that the non standard Input #2
is compatible with the peripheral device you wish to attach. Contact the Support desk for assistance
if you are unsure.
AC57: Input 1, DB9 male
| Pin | Signal | Notes |
|---|
| 1 | o/c | Not connected |
| 2 | RxD | Data coming from device and entering Mux for onward transmission to Host. |
| 3 | TxD | Optional return data path from Mux to device. Not connected unless jumper link is fitted. Default is fitted |
| 4 | DTR | Provides + 5v DC at up to 300mA to power devices |
| 5 | GND | Common data ground |
| 6 | DSR | Not connected |
| 7 | RTS | RS232 handshake line output. Permanently enabled (Wired to +12v via 1k resistor) |
| 8 | CTS | Not connected |
| 9 | o/c | Not connected |
AC57: Input 2, DB9 female
| Pin | Signal | Notes |
|---|
| 1 | CTS | Not Connected |
| 2 | RxD | Data coming from device and entering Mux for onward transmission to Host. |
| 3 | TxD | Optional return data path from Mux to device. Not connected unless jumper link is fitted. Default is not fitted |
| 4 | RTS | RS232 handshake line output. Permanently enabled (Wired to +12v via 1k resistor) |
| 5 | o/c | Not Connected |
| 6 | DSR | Not connected |
| 7 | GND | Common data ground |
| 8 | o/c | Not connected |
| 9 | DTR | Provides + 5v DC at up to 300mA to power devices |
AC57: Jumper Links and Data Switch
 AC57: View inside case
Summary
- Jumper Link Channel 1: Closed. Backward data path enabled
- Jumper Link Channel 2: Open. Backward data path disabled
- Data Switch: Toward Power Socket. Data injected into Host/Terminal pin 2 circuit.
|
Home
